Ian FREISLICH wrote:
quoted text
> I have two systems that I think are HT1000/HT2100 based.  They
> booted and installed 7-BETA1.5 (amd64) and happily build RELENG7
> about 3 weeks ago.  They don't have any PCI/PCI-X slots.  PCI-E
> works fine.  I used the onboard ATA DVD-ROM drive to install and
> the drive still works:
> 
> ATA channel 0:
>     Master: acd0 <HL-DT-STCD-RW/DVD-ROM GCC-T10N/A102> ATA/ATAPI revision 5
>     Slave:       no device present
> ATA channel 1:
>     Master:      no device present
>     Slave:       no device present
> ATA channel 2:
>     Master:      no device present
>     Slave:       no device present
> ATA channel 3:
>     Master:      no device present
>     Slave:       no device present
> 
> Disks are connected to a PCI-E LSI Megaraid so I can't verify the
> onboard SATA.  pciconf -lv later.
> 
> The only other quirk is the one set of USB ports on the front panel
> work if I have a keyboard plugged in at boot time, but stops working
> if I unplug the keyboard and plug it back in again.  The front panel
> monitor connection also doesn't work after a headless boot.  Anly
> the rear monitor and USB ports work properly after a boot.

My motherboard is PCI-X rather than PCI Express, though...

It could be real handy if you could verify that there's no problem with 
your onboard SATA in standard SATA (non-legacy) mode, if that box 
happens to be near you :)

You must be careful, though, any disk with existing data on it that you 
plug into the onboard SATA controller has a chance of being horribly 
corrupted just by booting from it, assuming you run into the same 
problems as us.

I am having the nasty data corruption problems using the onboard SATA 
controller as well as an 8-port Marvell SATA controller plugged into the 
motherboard's PCI-X slot. I've had no problems with the dvd-rom drive 
that's plugged into the onboard PATA controller.

I do not have any problem with a PCI SiI3114 SATA controller plugged 
into one of the 32-bit PCI slots.

If it helps anybody, I'll stick my pciconf -lv at the end of my post, too...

-- 
TerraNovaNet Internet Services - Key Largo, FL
Voice: (305)453-4011 x101   Fax: (305)451-5991
http://www.terranova.net/
----------------------------------------------
Life's not fair, but the root password helps.


pcib1@pci0:0:1:0:       class=0x060400 card=0x00000000 chip=0x00361166 
rev=0x00 hdr=0x01
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = 'HT1000 PCI/PCI-X bridge'
     class      = bridge
     subclass   = PCI-PCI
hostb0@pci0:0:2:0:      class=0x060000 card=0x02011166 chip=0x02051166 
rev=0x00 hdr=0x00
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = 'HT1000 Legacy South Bridge'
     class      = bridge
     subclass   = HOST-PCI
atapci1@pci0:0:2:1:     class=0x01018a card=0x02141166 chip=0x02141166 
rev=0x00 hdr=0x00
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = 'HT1000 Legacy IDE controller'
     class      = mass storage
     subclass   = ATA
isab0@pci0:0:2:2:       class=0x060100 card=0x02301166 chip=0x02341166 
rev=0x00 hdr=0x00
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = 'HT1000 LPC Bridge'
     class      = bridge
     subclass   = PCI-ISA
none0@pci0:0:3:0:       class=0x0c0310 card=0x02231166 chip=0x02231166 
rev=0x01 hdr=0x00
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = '0x0223 USB controller'
     class      = serial bus
     subclass   = USB
none1@pci0:0:3:1:       class=0x0c0310 card=0x02231166 chip=0x02231166 
rev=0x01 hdr=0x00
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = '0x0223 USB controller'
     class      = serial bus
     subclass   = USB
none2@pci0:0:3:2:       class=0x0c0320 card=0x02231166 chip=0x02231166 
rev=0x01 hdr=0x00
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = '0x0223 USB controller'
     class      = serial bus
     subclass   = USB
em0@pci0:0:4:0: class=0x020000 card=0x387010f1 chip=0x10768086 rev=0x05 
hdr=0x00
     vendor     = 'Intel Corporation'
     device     = '82541EI Gigabit Ethernet Controller'
     class      = network
     subclass   = ethernet
em1@pci0:0:5:0: class=0x020000 card=0x387010f1 chip=0x10768086 rev=0x05 
hdr=0x00
     vendor     = 'Intel Corporation'
     device     = '82541EI Gigabit Ethernet Controller'
     class      = network
     subclass   = ethernet
vgapci0@pci0:0:6:0:     class=0x030000 card=0x002018ca chip=0x002018ca 
rev=0x00 hdr=0x00
     vendor     = 'XGI Technology Inc'
     class      = display
     subclass   = VGA
atapci2@pci0:0:7:0:     class=0x010400 card=0x61141095 chip=0x31141095 
rev=0x02 hdr=0x00
     vendor     = 'Silicon Image Inc (Was: CMD Technology Inc)'
     device     = 'Sil 3114 SATALink/SATARaid Controller'
     class      = mass storage
     subclass   = RAID
hostb1@pci0:0:24:0:     class=0x060000 card=0x00000000 chip=0x11001022 
rev=0x00 hdr=0x00
     vendor     = 'Advanced Micro Devices (AMD)'
     device     = '(K8) Athlon 64/Opteron HyperTransport Technology 
Configuration'
     class      = bridge
     subclass   = HOST-PCI
hostb2@pci0:0:24:1:     class=0x060000 card=0x00000000 chip=0x11011022 
rev=0x00 hdr=0x00
     vendor     = 'Advanced Micro Devices (AMD)'
     device     = '(K8) Athlon 64/Opteron Address Map'
     class      = bridge
     subclass   = HOST-PCI
hostb3@pci0:0:24:2:     class=0x060000 card=0x00000000 chip=0x11021022 
rev=0x00 hdr=0x00
     vendor     = 'Advanced Micro Devices (AMD)'
     device     = '(K8) Athlon 64/Opteron DRAM Controller'
     class      = bridge
     subclass   = HOST-PCI
hostb4@pci0:0:24:3:     class=0x060000 card=0x00000000 chip=0x11031022 
rev=0x00 hdr=0x00
     vendor     = 'Advanced Micro Devices (AMD)'
     device     = '(K8) Athlon 64/Opteron Miscellaneous Control'
     class      = bridge
     subclass   = HOST-PCI
pcib2@pci0:1:13:0:      class=0x060400 card=0x4f00d7f7 chip=0x01041166 
rev=0xc0 hdr=0x01
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = 'HT1000 PCI/PCI-X bridge'
     class      = bridge
     subclass   = PCI-PCI
atapci0@pci0:1:14:0:    class=0x010405 card=0x024a1166 chip=0x024a1166 
rev=0x00 hdr=0x00
     vendor     = 'ServerWorks (Was: Reliance Computer Corp)'
     device     = 'BCM5785 (HT1000) SATA Native SATA Mode'
     class      = mass storage
     subclass   = RAID
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe@freebsd.org"