+static int pch_gbe_probe(struct pci_dev *pdev,
+ const struct pci_device_id *pci_id)
+{
+ struct net_device *netdev;
+ struct pch_gbe_adapter *adapter;
+ unsigned long mmio_start;
+ unsigned long mmio_len;
+ int i, ret;
+
+ PCH_GBE_DEBUG("pch_gbe_probe\n");
+ ret = pci_enable_device(pdev);
+ if (ret)
+ return ret;
+
+ if (!dma_set_mask(&pdev->dev, DMA_BIT_MASK(64))
+ && !dma_set_coherent_mask(&pdev->dev, DMA_BIT_MASK(64))) {
+ ;
+ } else {
+ ret = dma_set_mask(&pdev->dev, DMA_BIT_MASK(32));
+ if (ret) {
+ ret = dma_set_coherent_mask(&pdev->dev,
+ DMA_BIT_MASK(32));
+ if (ret) {
+ printk(KERN_ERR KBUILD_MODNAME ": ERR: "
+ "No usable DMA configuration, aborting\n");
+ goto err_disable_device;
+ }
+ }
+ }
+ ret = pci_request_regions(pdev, KBUILD_MODNAME);
+ if (ret) {
+ printk(KERN_ERR KBUILD_MODNAME ": "
+ "ERR: Can't reserve PCI I/O and memory resources\n");
+ goto err_disable_device;
+ }
+ pci_set_master(pdev);
+
+ netdev = alloc_etherdev((int)sizeof(struct pch_gbe_adapter));
+ if (!netdev) {
+ ret = -ENOMEM;
+ printk(KERN_ERR KBUILD_MODNAME ": "
+ "ERR: Can't allocates and sets up an Ethernet device\n");
+ goto err_release_pci;
+ }
+ SET_NETDEV_DEV(netdev, &pdev->dev);
+
+ pci_set_drvdata(pdev, netdev);
+ adapter = netdev_priv(netdev);
+ adapter->netdev = netdev;
+ adapter->pdev = pdev;
+ adapter->hw.back = adapter;
+ mmio_start = pci_resource_start(pdev, PCH_GBE_PCI_BAR);
+ mmio_len = pci_resource_len(pdev, PCH_GBE_PCI_BAR);
+ adapter->hw.reg = ioremap_nocache(mmio_start, mmio_len);
+ if (!adapter->hw.reg) {
+ ret = -EIO;
+ printk(KERN_ERR KBUILD_MODNAME ": " "Can't ioremap\n");
+ goto err_free_netdev;
+ }
+
+ netdev->netdev_ops = &pch_gbe_netdev_ops;
+ netdev->watchdog_timeo = PCH_GBE_WATCHDOG_PERIOD;
+ netif_napi_add(netdev, &adapter->napi,
+ pch_gbe_napi_poll, PCH_GBE_RX_WEIGHT);
+ strncpy(netdev->name, pci_name(pdev), (int)sizeof(netdev->name) - 1);
+ netdev->mem_start = mmio_start;
+ netdev->mem_end = mmio_start + mmio_len;
+ netdev->features = NETIF_F_HW_CSUM;
+ pch_gbe_set_ethtool_ops(netdev);
+
+ pch_gbe_mac_reset_hw(&adapter->hw);
+
+ /* setup the private structure */
+ ret = pch_gbe_sw_init(adapter);
+ if (ret)
+ goto err_iounmap;
+
+ /* Initialize PHY */
+ ret = pch_gbe_init_phy(adapter);
+ if (ret) {
+ printk(KERN_ERR KBUILD_MODNAME ": " "PHY initialize error\n");
+ goto err_free_adapter;
+ }
+ pch_gbe_hal_get_bus_info(&adapter->hw);
+
+ /* Read the MAC address. and store to the private data */
+ ret = pch_gbe_hal_read_mac_addr(&adapter->hw);
+ if (ret) {
+ printk(KERN_ERR KBUILD_MODNAME ": " "MAC address Read Error\n");
+ goto err_free_adapter;
+ }
+
+ memcpy(netdev->dev_addr, adapter->hw.mac.addr, netdev->addr_len);
+ if (!is_valid_ether_addr(netdev->dev_addr)) {
+ printk(KERN_ERR KBUILD_MODNAME ": " "Invalid MAC Address\n");
+ ret = -EIO;
+ goto err_free_adapter;
+ }
+
+ init_timer(&adapter->watchdog_timer);
+ adapter->watchdog_timer.function = &pch_gbe_watchdog;
+ adapter->watchdog_timer.data = (unsigned long)adapter;
+
+ INIT_WORK(&adapter->reset_task, pch_gbe_reset_task);
+
+ pch_gbe_check_options(adapter);
+
+ if (adapter->tx_csum)
+ netdev->features |= NETIF_F_HW_CSUM;
+ else
+ netdev->features &= ~NETIF_F_HW_CSUM;
+
+ /* initialize the wol settings based on the eeprom settings */
+ adapter->wake_up_evt = PCH_GBE_WL_INIT_SETTING;
+ for (i = 0; i < 6; i++)
+ printk(KERN_INFO "%2.2x%c",
+ netdev->dev_addr[i], i == 5 ? '\n' : ':');
This is wrong since it produces KERN_INFO tag without newline, and probably
you just want:
printk(KERN_INFO "%pM", netdev->dev_addr);
or better yet, convert to dev_printk
+
+ /* reset the hardware with the new settings */
+ pch_gbe_reset(adapter);
+
+ strcpy(netdev->name, "eth%d");
This is unnecessary since you used alloc_etherdev()
+ ret = register_netdev(netdev);
+ if (ret)
+ goto err_free_adapter;
+ /* tell the stack to leave us alone until pch_gbe_open() is called */
+ netif_carrier_off(netdev);
+ netif_stop_queue(netdev);
+
+ PCH_GBE_DEBUG("OKIsemi(R) PCH Network Connection\n");
+
+ device_set_wakeup_enable(&pdev->dev, 1);
+ return 0;
+
+err_free_adapter:
+ pch_gbe_hal_phy_hw_reset(&adapter->hw);
+ dev_put(adapter->polling_netdev);
+ kfree(adapter->tx_ring);
+ kfree(adapter->rx_ring);
+ kfree(adapter->polling_netdev);
+err_iounmap:
+ iounmap(adapter->hw.reg);
+err_free_netdev:
+ free_netdev(netdev);
+err_release_pci:
+ pci_release_regions(pdev);
+err_disable_device:
+ pci_disable_device(pdev);
+ return ret;
+}
--
