> On some CPUs, a ple_gap of 41 is simply insufficient to ever trigger
> PLE exits, even with the minimalistic PLE test from kvm-unit-tests.
>
>
http://git.kernel.org/?p=virt/kvm/kvm-unit-tests.git;a=commitdiff;h=eda71b28fa122203e3...
>
> For example, the Xeon X5670 CPU needs a ple_gap of at least 48 in
> order to get pause loop exits:
>
> # modprobe kvm_intel ple_gap=47
> # taskset 1 /usr/local/bin/qemu-system-x86_64 -device testdev,chardev=log -chardev stdio,id=log -kernel x86/vmexit.flat -append ple-round-robin -smp 2
> VNC server running on `::1:5900'
> enabling apic
> enabling apic
> ple-round-robin 58298446
> # rmmod kvm_intel
> # modprobe kvm_intel ple_gap=48
> # taskset 1 /usr/local/bin/qemu-system-x86_64 -device testdev,chardev=log -chardev stdio,id=log -kernel x86/vmexit.flat -append ple-round-robin -smp 2
> VNC server running on `::1:5900'
> enabling apic
> enabling apic
> ple-round-robin 36616
>
> Increase the ple_gap to 64 to be on the safe side.
>
> Is this enough for a CPU with HT that has a busy sibling thread, or
> should it be even larger? On the X5670, loading up the sibling thread
> with an infinite loop does not seem to increase the required ple_gap.
>
> Signed-off-by: Rik van Riel <riel@redhat.com>
>
> diff --git a/arch/x86/kvm/vmx.c b/arch/x86/kvm/vmx.c
> index 81fcbe9..0e38b8e 100644
> --- a/arch/x86/kvm/vmx.c
> +++ b/arch/x86/kvm/vmx.c
> @@ -90,14 +90,14 @@ module_param(vmm_exclusive, bool, S_IRUGO);
> * These 2 parameters are used to config the controls for Pause-Loop Exiting:
> * ple_gap: upper bound on the amount of time between two successive
> * executions of PAUSE in a loop. Also indicate if ple enabled.
> - * According to test, this time is usually small than 41 cycles.
> + * According to test, this time is usually smaller than 64 cycles.
> * ple_window: upper bound on the amount of time a guest is allowed to execute
> * in a PAUSE loop. Tests indicate that most spinlocks are held for
> * less than 2^12 cycles
> * Time is measured based on a counter that runs at the same rate as the TSC,
> * refer SDM volume 3b section 21.6.13 & 22.1.3.
> */
> -#define KVM_VMX_DEFAULT_PLE_GAP 41
> +#define KVM_VMX_DEFAULT_PLE_GAP 64
> #define KVM_VMX_DEFAULT_PLE_WINDOW 4096
> static int ple_gap = KVM_VMX_DEFAULT_PLE_GAP;
> module_param(ple_gap, int, S_IRUGO);
>
>
