Home » Forums » Other » Hardware

BCM5395S Switch

Submitted by sathya
on October 30, 2008 - 4:17am

Hi All,

I am using BCM 5395S ( 5-port giga switch) switch in my project. In that If i enable the 8021q ( to separate one port from other 4 ports) , then I am getting a lot of frame loss in IXIA tests. Can any one one point me some settings that I have to make additionally other than setting the forward and un-tag maps, to avoid these frame losses.

I have made a test without 8021q settings, With that I am getting zero frame loss.. Any inputs please ?

‹ Atmel AVRONE! a JTAG / Extended Debugging Device not see by "lsusb" About Net2280 PCI to USB 2.0 peripheral device controller ›

Hi, Do you use the port-vlan

Anonymous (not verified)
on
October 31, 2008 - 1:52pm

Hi,

Do you use the port-vlan feature of the switch or just the normal vlan features to seperate a port?
Can you tell me on which port the frame loss occurs, you can read that out of the mibcounters of a port. this can give a clue why frames are getting dropped. Do you use autoneg to configure the ethernet phys?

regards

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.